Zone Offroad D50 4.5 inch Standard Lift Kit - 3 inch Rear Lift Blocks | 2013-2018 RAM 3500 6.7L Cummins 4WD

• Corrects suspension, steering, and driveline geometry for great on-road handling and improved off-road performance.
• Full length replacement coil springs add additional ride height while maintaining ride quality.
• High-strength control arm relocation brackets correct suspension geometry and add rigidity.

Description

• 2013-2018 Dodge Ram 3500 4WD/Diesel
• Fits models with 3" rear lift blocks

• Front Lift Height: 4.5"
• Rear Lift Height: 3"
• Front Lift Method: Radius Arm Drop
• Rear Lift Method: Cast Blocks
• Lift Type: Lift Kit
• Wheel Size: 20 x 9
• Back Spacing: 5.75"
• Max Tire Size: 37 x 12.5
• Wheel Size 2: 17 x 9
• Back Spacing 2: 5.75"
• Max Tire Size 2: 37 x 12.5
• Wheel Size 3: 17 x 9
• Back Spacing 3: 4.5"
• Max Tire Size 3: 35 x 12.5
• Finish: Powdercoat
• Cutting Required: No
• Accommodates Factory Wheels: See Notes
• Welding Required: No

• Driveline Notice: Front driveline vibration may occur at speeds over 35 mph when in 4WD. If this occurs, install the appropriate t-case indexing kit to reduce front driveline angle.
• Fitment: Does NOT work for models with factory rear airbag suspension.
• Fitment: This kit is not designed for dually models, but may me easily adapted to accommodate your truck. Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.

• All Necessary Mounting / Installation Hardware
• Bump Stops
• Coil Springs
• Dropped Pitman Arm
• Radius Arm Drop Brackets
• Rear Lift Block & U-Bolt Kit
• Sway Bar Relocation Brackets
• Track Bar Relocation Bracket