BDS 2242FS 5 Inch Lift Kit w/ Radius Arm, FOX 2.5 Performance Elite Shocks & 5 Inch Block Kit w/o Overload | 2023-2025 Ford F250/F350 Super Duty 4WD Diesel

Features:

• 5-inch lift for aggressive stance
• Clears up to 37-inch tires
• Diesel-specific Pro-Ride coil springs
• Heavy-duty tubular radius arms
• FOX 2.5 Performance Elite shocks
• Dual Speed Compression adjusters included
• External reservoirs for shock cooling
• Fully serviceable shock design
• Forged drop pitman arm for steering
• Track bar relocation for axle centering
• Fabricated 5-inch rear lift blocks
• 100% bolt-on installation

Unlock A New Level Of Ride Confidence

If you're looking to lift your 2023-2025 Ford F250 or F350 Super Duty diesel and actually improve the ride quality while doing it, this BDS 5-inch radius arm kit delivers in all the right ways. This isn’t just about getting more height, it’s about completely transforming your truck's stance, control, and capability. Whether you're hauling a heavy trailer or just want to fit those aggressive 37-inch tires, this kit sets you up to do it with confidence and style. The included FOX 2.5 Performance Elite shocks bring serious off-road performance to the table, with external reservoirs and Dual Speed Compression adjusters that let you fine-tune your ride based on terrain or load. Up front, the heavy-duty radius arms add strength and improve handling, while the Pro-Ride coil springs give your truck that balanced, controlled ride across pavement, gravel, or dirt. And because everything bolts on with no cutting or welding, the install is straightforward and completely reversible. You’re not just lifting your truck, you’re upgrading its entire attitude.

Built To Handle The Toughest Roads And Loads

This BDS 2242FS lift kit was engineered from the ground up to meet the demands of serious Super Duty owners. The diesel-specific Pro-Ride dual rate coil springs up front ensure consistent ride height and comfort whether the truck is empty or loaded down. Heavy-duty tubular radius arms replace the factory stamped steel for added strength and built-in caster correction, helping maintain smooth and responsive steering at any lift height. To bring the steering geometry back into spec, a forged drop pitman arm and a track bar relocation bracket are included, keeping the front axle centered and handling tight. Out back, the 5-inch fabricated steel lift blocks provide a level stance while retaining ride quality, supported by longer u-bolts and extended brake line brackets. The FOX 2.5 shocks use a massive 7/8-inch chrome plated shaft and a fully serviceable body, making them ready for years of rugged use. Every component has been carefully matched for a system that feels refined on the road but is fully capable when the pavement ends.

Fits: 2023, 2024, 2025 Ford F250/F350 Super Duty 4WD Diesel

Notes:

• Vehicles with radius arm mounted ride height sensors will require BDS123303
• Ford recommends replacing the pitman arm nut after each removal
• Use a small pitman arm puller to remove drag link joint and steering stabilizer taper
• Trucks with a 2-piece rear driveshaft may need Carrier Bearing Drop Kit BDS123402
• Tremor models will not achieve full advertised lift height due to taller factory stance
• Stock wheels with larger tires may cause interference with brake lines, radius arms, and sway bars
• Minor trimming may be required for 37x12.50 tires depending on wheel setup
• Installation requires a torque wrench capable of 406 ft-lbs
• Vehicles with leaf spring ride height sensors must choose the correct rear block option
• Kit is designed for SRW (Single Rear Wheel) models only
• ADAS systems may require recalibration after installation by a dealership or ADAS service center
• All ADAS recalibration costs are the responsibility of the vehicle owner

Install Instructions